Plug the pump unit back in and turn it back on.Turn the pump unit off and unplug from the socket (leave for 10 seconds).Press the test button once and leave it bleeping (leave for 10 seconds). IMPORTANT: Before you restart the pump, press the reset button. Unplug the pump and plug it back in once the water temperature has reached 38✬ (100✯) or lower. The Lay-Z-Spa is not designed to operate with water temperatures exceeding 40✬ (104✯). The water temperature is over 50✬ (122✯). Place the stopper caps inside the spa, disconnect the pump unit, and bring the pump unit inside to cool down. Please contact us for more help with this If the above troubleshooting has not resolved the problem, the water flow sensors may not be working. Using your hands, check the condition of the pipes within the liner. Pipes within the liner are kinked or bent. If no alarm appears, you will need to clean or replace the filter cartridges.Įnsure that the debris screens are clear of debris. Remove the filter cartridges from the pump and press the filter or heat button. If you’re unsure how to remove them, refer to the assembly section within the Lay Z Spa Owner’s Manual. Remove the stopper caps before heating your Lay-Z-Spa. The stopper caps are still inside the spa.
0 Comments
Leave a Reply. |